Q. I am growing healthy bottle tree in a very large concrete container in Queensland, Australia. The lower branches have been turning brown and then falling off. Is this typical behavior as this tree grows taller or a water problem? I am watering maybe 2-3 times a week using a handheld hose.  We are currently moving into our summer with very warm to hot days. A. All bottle trees (Brachychiton populneus and B. rupestris) growing in containers or pots presents its own set of problems (primarily heat, soil, and water management) that growing them in the ground does not. I would encourage you to think about planting in the ground if possible. Our bottle trees get big! So do Australian-type bottle trees! Bottle Trees in Australia are Different Than Ours             In Australia they sometimes call Brachychiton rupestris a bottle tree. In the US, Brachychiton populneus is called the Australian bottle tree. Both are natives to you but rupestis gets the typical bottle look when younger while populneus gets a bottle shape that is not as exaggerated. Dropping of lower limbs may be natural with that species if they get eight years old. Hard to know since it depends on how old it got and if the trunk was starting to swell. Be careful when putting bottle trees in lawns. These trees don’t like lawns because lawns are watered too often. They are native to Queensland and Victoria, New South Wales, Australia and prefer soils that have good drainage and are not watered frequently. Heat Management of Containers I would suggest growing them in double pots. The outside container creates shade and acts like a heat protector for the roots. When the sun shines on the pot directly it can damage or kill about 50% of the roots due to heating up of the soil.             The surface of dry containers, when the air temperature is 105F, is about 175F. Plant roots can handle temperatures at about 135F. I tell people to water their plants just before the heat of the day. As trees get older their roots occupy more of the container and this can be a significant problem during the summer. Root growth occupies space. Bottle trees, Brachychiton populneus, can sunburn on upper branches because of its thin bark. It is easily vandalized as well. Soil Management of Containers Soil in containers “wear out” (depletes) in about five years and should be changed or amended every three to five years. I would discourage you from growing a large tree (bottle trees mature at about 50 or 60 feet) in containers. Most containers are not large enough to handle tall trees and their roots as they get larger. Containers are better suited for smaller plants like limes, calamondin, and finger limes. Water Management The usual problem with bottle trees is poor drainage and watering too often. The roots will rot if they get a continuous water supple and the soil stays wet. Digging them up when roots are rotting is usually accompanied with a putrid smell as the roots rot. When watering by hand about one fourth of the applied water should come out the bottom to remove salt.             If you can’t control the water in the soil (drainage) or the application of water, then plant the tree on a “hill” that is at least one foot higher than the surrounding soil and six feet in diameter. Cover the soil with a 2-to-3-inch layer of surface mulch, either rock or woodchips.